When working with Hypalon glue, it is important to take safety precautions to avoid exposure to fumes and skin contact with the glue.

This means that any repairs you set out to do yourself will require Stabond as the adhesive unless the boat was made before 1968.

Jun 10, 2011 · fc-falcon">Cut the patch to extend 2" beyond all edges of the tear. .

Solvent based polychloroprene rubber adhesive gives high strength.

class=" fc-falcon">SKU: stabond4oz.

May 8, 2014 · clean the area with acetone and a scrubbie, the tape off the area, apply 2 to 3 coats of glue letting each dry to tacky, make sure to do both sides, then press together. . .

Mask the area that needs to be repaired to avoid excess application of adhesive.

. . Buy the stuff that says Hypalon glue right on the label.

You want to use a two part contact adhesive. .

We used.

The first three steps are for preparing and assessing the appropriate size patch to affix to your boat.

to clean any urethane or PVC materials and use toluene to clean any Hypalon or synthetic rubber materials. See website for Repair kits/Adhesives/Accessories ect https://ribright.

<strong>Hypalon Adhesive (full hypalon repair guide). Read the instructions on the label.

Dec 9, 2018 · Glue Brush; Pusher Tool (or something firm to push the air bubbles out with) Respirator and Heavy Duty Rubberized Gloves; Step-by-Step Guide.
It can be used even normal neoprene glue, but it is not designed for high resistance use.

For Hypalon and PU patches, abrade the back to achieve a key for the application of adhesives.

Download MSDS Sheets.

Mask the area that needs to be. . Carefully join the surfaces, avoiding trapped air.

Trace the area of the patch on the damaged surface with a pencil. I don't think UV could have caused your problem. This adhesive bonds together Hypalon, neoprene, latex, nylon, PVC, and a number of other materials, fabrics, foams, and plastics. <strong>Hypalon Adhesive (full hypalon repair guide). Fourth, once the adhesive has dried, apply a Hypalon patch over the repair area and press it firmly into place.

Second what A64 said.

If applying a Hypalon fabric patch or synthetic rubber tube handle etc onto a PVC tube or collar, thoroughly abrade the back (the dull/matt/’rubber feel. Step 5.

Second, clean the area with a mild soap and water solution and allow it to dry completely.

Carefully join the surfaces, avoiding trapped air.


I also attached some.

Method: First abrade surface of the rubber component, then clean and coat with a thin layer of Hypalon adhesive (2990) as a primer.